Press the button to return to the Scanning Mode Use the OK button to cycle through the different adjustments. Use the and buttons to adjust the selected setting. You can adjust the frame position by going to Frame ADJ on the main menu. IMPORTANT: The frame can only be adjusted before recording your video.

Once you have chosen your sharpness, press the OK button.

Use the and buttons to change the sharpness to either Low, Medium, or High.

You can adjust the sharpness by going to Sharpness on the main menu.

IMPORTANT: Sharpness can only be adjusted before recording your video.

Once you have chosen the value, press the OK button.

Use the and buttons to change the brightness value between 2.0 (brighter) and – 2.0 (darker).

You can adjust the exposure by going to Exposure on the main menu.

IMPORTANT: Exposure can only be adjusted before recording video. This is normal.Īdjusting Your Scan Settings Exposure (Brightness) Note: Switching film types will prompt the reel motor to adjust. Selecting Film TypeĬhange the film type to either 8mm or Super 8 by pushing the film type lever on the film scanner left or right.

Once the film is secured under the tabs close the film tray door to lock the film in place during scanning.

Insert the film ensuring that the film’s perforated holes are at the back and placed under the two white tabs located on the film tray.

Slide the Open tab to the left to release the film tray door latch.

Hold the film in place for the first rotation. Gently rotate the reel 2-3 times to secure

Place the film around the empty film reel on the right, placing the end of the film into the slot on the reel.

Feed your film along the dotted film route line on the film scanner to properly load the film onto the scanner.

If using a different reel use the grey reel adapter as needed. Install the included ?”film reel onto the right reel shaft of the scanner.Note: If using with Super 8 film you will need to install the red reel adapter. Ensure the perforated holes on your film are on the inside, closest to the scanner. Install your film reel onto the left reel shaft.This scanner can support 8mm or Super 8 film on 3′: 5″ or 7″ reels. Connect the power adapter into the DC 12V port at the back of the outlet.

IMPORTANT: Inserting an SD Card after powering on the scanner will cause the scanner to IMPORTANT: Inserting an SD Card after powering on the scanner will cause the scanner to shut o An SD card (CLASS 4 or above) is required in order to scan and save video.

Insert an SD card (not included) into the SD card slot at the back of the lm scanner.

Manual magna sirgas pro 2.0